YGM Raymond Mill Introduction

 

The Raymond mill structure is mainly composed of a main unit, an analyzer, a fan, a finished cyclone separator, a fine powder cyclone separator and a duct. Among them, the main body is composed of a frame, an inlet volute, a blade, a grinding roller, a grinding ring and a cover.

 

The grinding roller is tightly pressed on the grinding ring under the action of centrifugal force, so that when the grinding roller and the grinding ring are worn to a certain thickness, the yield and fineness of the finished product are not affected. The replacement cycle of the grinding roller and the grinding ring is long, so that the shortcomings of the replacement period of the wearing parts of the centrifugal pulverizer are eliminated. The air-selected airflow of the machine is circulated and flowed in the fan-grinding shell-cyclone-fan, so it has less dust than the high-speed centrifugal pulverizer, the operation workshop is clean, and the environment is pollution-free.

 

 

Key to Success of Clirik YGM Raymond Mill

 

Easy to transport and install

 

With its unique structural design, it occupies a smaller space and is more convenient for transportation, installation, operation and maintenance;

 

Efficient, less polluting

 

The Raymond mill produced by our company adopts PLC electrical automation control, which effectively reduces the failure rate and labor cost of the equipment, realizes high-yield and high-efficiency production, and achieves a good production environment with low noise and less pollution;

 

Fineness can be adjusted freely

 

Powder grinding fineness can be adjusted between 50-450 mesh, and the applicability is more flexible and wide. Clirik Raymond mill is the best choice for non-metallic ore grinding.

 

Long parts replacement cycle

 

The replacement cycle of the grinding roller and the grinding ring is long, so that the shortcomings of the replacement period of the wearing parts of the centrifugal pulverizer are eliminated.